PLT4G is an epoxy-based two-component ink.

plt4 colors

Click to view Ink Color Chart.


PLT4G ink is a two-component series ink that is dust dry in about 20 minutes. Remarkable for its good coverage. This ink has a semi-gloss to gloss finish depending on the printing surface. After proper curing, products printed with PLT4G may be silvered using common silver-plating methods.


Particularly suited for printing on glass, and ceramics such as glass panes, glass bottles, ornamental glasses, ceramic tiles, ferrous and non-ferrous metals. Good results are also obtained on thermo-setting materials in general.


PLT4G has an excellence resistance to many organic solvents and chemical products. To increase the water and weather resistance, we recommend to heat the ink using an oven at 175° F for 4-6 minutes.

Flash Point

Above 48° C.


As a two-component ink, PLT4G must be mixed with PLHG hardener and thinner before use. Mix in ratio of 20 parts ink to 1 part hardener. It is recommended that the mixed ink be allowed to rest for 15-20 minutes before printing. Thin and mix well with PLTB thinner in a portion of 10-20% maximum.

In warm climates and in the presence of fine details or screened images, the use of PLTD retarder in a small percentage is recommended.

Pot Life

The life of the mixed ink is 8-10 hours after which the mechanical-chemical resistance and adhesion decrease. This is also dependent on room temperature and ratio of solvent.
An excessive dilution causes a loss of coverage, smudges and incomplete ink transfer from the pad. A poor dilution may cause problems lifting the image from the cliché, affecting print quality.

Drying and Hardening

Generally the following drying times are applicable:
Air drying at 68° F: 20-30 seconds Heat drying at 175° F: Approx. 3 -5 minutes Full curing at 68° F: 24 hours
The final hardening of the ink is obtained after 24 hours. If the printed products require exceptionally high water resistance or resistance to other substances, the ink should be baked at 284° F for 30-60 minutes.
Please note drying times are substrate specific.

Range of Colors

PLT4G is limited to 8 opaque colors as well as 3 transparent, four color process shades. Europa scale is available in the transparent colors. PLT4G has a high light fastness equivalent to 7-8 rating on the DIN 16525. PLT4G inks are adjusted for printing with PLTB Thinner, and PLTD Retarder for printing fine detail.

Process Color Printing

PLT4G inks are available in transparent colors PLT4G #180 Yellow, PLT4G #181 Magenta and PLT4G #182 Cyan.


PLT4G has a shelf life of about 2 years. Storage containers should be sealed and placed in a cool and dry place. PLH Hardener should not be stored for long periods. The cans should be closed immediately after use, otherwise the hardener will take on moisture and become thick and ineffective.