Ink Adhesion Testing

Home / Services / Ink Adhesion Testing

Ink Adhesion Testing is a free service provided to our customers. You can submit your information using the form on this page or call the EPS Customer Service department directly at (800)-272-7764 to find out more about this service. We require that you send us sample product as the initial step in this process. As a part of this free service we will provide the imprinted sample (if return requested), a corresponding report with our recommendations, and a consultation with our internal teams to discuss the next steps.

 

Below is additional information regarding surface material structure.

The surfaces of plastics and other materials vary not only in terms of texture, but in terms of surface tension, too – a characteristic also referred to as “surface energy” or “surface wetting”.

If the surface tension of a substrate is lower than the surface tension of the ink, the ink won’t stick. It’s a sign of inadequate chemical covalent bonding & “bad ink adhesion,” in layman’s terms. Likewise, if the substrate is wettable, that is, if it has high surface energy, the ink will adhere properly to the surface, allowing it to be marked or decorated.

 

One simple test of a plastic’s printability is to drip some water on the surface. If the water beads up, the surface energy of the substrate is lower than the surface tension of the water, and vice versa. If the water “sheets” its surface tension is lower than the substrates’. Beading is bad. Sheeting is good.

 

The scientific test is to check the surface of your plastic using a dyne kit (image above). These specialized dyne markers contain a fluid that mimics ink adhesion and allows printers to choose the type of ink that will most likely stick to the product’s surface.

 

One simple test of a plastic’s printability is to drip some water on the surface. If the water beads up, the surface energy of the substrate is lower than the surface tension of the water, and vice versa. If the water “sheets” its surface tension is lower than the substrates’. Beading is bad. Sheeting is good.

 

The scientific test is to check the surface of your plastic using a dyne kit (image above). These specialized dyne markers contain a fluid that mimics ink adhesion and allows printers to choose the type of ink that will most likely stick to the product’s surface.

Interested in learning more about this FREE service? Complete the form below.

Note: Under no circumstance, will we sell, share or otherwise distribute your data outside EPS.